3-D graphics

Home › Forums › Tactile Graphics › 3-D graphics

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 3, 2019 at 10:17 am #33226
    Cheryl Walcutt
    Participant

    I am producing a 7th grade math book.  The attached doc shows 3-D images with cross sections.  The tactileView graphics that I am producing look a little confusing.  Any suggestions.

    Attachments:
    You must be logged in to view attached files.
    April 3, 2019 at 1:39 pm #33229
    Braillekey
    Participant

    Hi Cheryl, thank you for writing in to the NBA Ask an Expert Forum. Although I don't use TactileView Graphic software, the provided images appear to have been traced using quick auto tracing within the TactileView Graphic software.

    The image should be traced using a line creation tool rather than tracing tools. If you do opt to trace, you must convert the lines into a proper line weight as shown in Appendix F of Guidelines and Standards. Verify that all lines reflect what is shown in print. For instance, if two lines on opposite ends (right and left) of the graphic run parallel to each other in print, make sure that these are straight and truly parallel in the tactile graphic version. Also, verify that your 90 degree angles are properly done as well.

    • This reply was modified 5 years, 8 months ago by Braillekey.
    • This reply was modified 5 years, 8 months ago by Braillekey.
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

Everyone is free to read the forums, but only current NBA members can post. Become a member today. Click here to Login and return.